Denon DN-720R - Manual (Page 7)

Tape transport controls
►
PLAY
PLAY button Press to playback tape.
STOP STOP button Press to stop tape in any mode.
<< REW button Press for fast rewind.
>> FF button Press fast forward tape winding.
To begin recording, press the RECORD and PLAY button simultaneously. If only the
RECORD button is pressed, the deck is placed in the REC PAUSE (record standby) mode.
• REC/REC MUTE RECORD/MUTE button When this button is pressed under the REC PAUSE state, the mode shifts to the Auto Rec
Mute. when this button is pressed for making a non-recorded part between two
melodies, about 5 sec of non-recorded part can automatically be created.
ll PAUSE PAUSE button Press this button to enter the recording pause mode from the recording or recording
mute mode. Press this button to enter the playback pause mode from playback mode.
CASSETTE TAPES
• Handling Precautions
• C-120 Cassettes
C-120 cassette tapes are not recommended as they use a very thin tape
base which may become tangled around the capstan or pinchroller.
• Tape Slack
This cassette deck incorporates an automatic tape slackness preventive
mechanism, but it can not prevent such a slackness as shown below.
Remove it with a pencil or the like prior to use.
AUTO TAPE SELECT FEATURE
• Storage Precautions
Do not store cassette tapes in a place where they will be subject to:
• Extremely high temperature or excessive moisture
• Excessive dust
• Direct sunlight
• Magnetic fields (near TV sets or speakers)
To eliminate tape slack, store your cassettes in cassette cases with hub stops
• Accidental Erasure Prevention
Every cassette has erasure prevention tabs for each side. To protect your valuable
recorded tapes from accidental or inadvertent erasure, remove the tab for the
appropriate side with a screwdriver or other tools.
To record on a tape with the erasure prevention tabs removed, cover the tab holes
with plastic tape.
This Stereo Cassette Deck contains an Auto Tape Select feature which automatically selects
the optimum bias and equalization for the tape in use. This is accomplished by detection of
tape type detection holes in the cassette housing.
• If a tape without tape type detection holes is used, the deck will
automatically adjust itself for normal tapes.
7