Foxconn Avenger - Manual (Page 29)

22
2
2-6 onboard button
Power on button: PoWER_oN
Push the power on button to power on the system.
Reset button: REsET
Push the reset button to reboot the system.
Clear CMos button: Cls_CMos
Turn off the AC power supply, push the CLS_CMOS button
and hold there for a couple of seconds to clear CMOS.
2-7 onboard lED
+5V standby lED:
It will light whenever the power supply that connected to
the motherboard is switched on.
2-8 Onboard Debug LED
2-digital LED readout displays hardware status and
enables quick error diagnosis.
POWER_ON RESET CLS_CMOS
■ Make sure the power supply is turned off before pressing the CLS_CMOS button to
clear CMOS.
■ Push down the CLS_CMOS button and hold it there for a couple of seconds to clear
the CMOS completely, then release.
CA
UT
IO
N
!
Do not remove or plug in any device when the
onboard LED is lighting on.
WA
RNING!