Freecom Tough Drive Custom - Manual (Page 20)

0
EN
5
Freecom ToughDrive Custom
Chapter 5: Using Freecom Turbo USB .0 (only PC)
By installing the Turbo USB 2.0 driver for your ToughDrive Custom, the data transfer rate
can be significantly increased (up to 40% faster transfer speed compared to standard
High-Speed USB).
Enabling the Turbo USB .0 driver
1. Connect the Freecom ToughDrive Custom to your PC.
2. Run “Start.exe” from your ToughDrive Custom and go to Software Installation ->
Freecom Turbo USB 2.0.
3. The Freecom Turbo USB 2.0 Wizard will open.
4. Check the drive and click on “Configure” to enable the Turbo USB2.0 driver for the
Freecom ToughDrive Custom.
Disabling the Turbo USB .0 driver
5. Connect the Freecom ToughDrive Custom to your PC.
6. Run “Start.exe” from your ToughDrive Custom and go to Software Installation ->
Freecom Turbo USB 2.0.
7. The Freecom Turbo USB 2.0 Wizard will open. Uncheck the drive and click on “Configure”
to disable the Freecom Turbo USB 2.0 driver for the Freecom ToughDrive Custom.