FSR RN-8200 - Manual (Page 46)

4.0 Factory Default Settings
RN-8200 Reference Manual Page 4-1
4.0 FACTORY DEFAULT SETTINGS
All device settings are configurable using the CU. The factory default settings for the Room Navigator are as
follows:
Serial Port 0: 9600 baud, 8-N-1 (8 data bits, no parity, 1 stop bit), no flow control, Echo Mode OFF
Serial Port 1: 9600 baud, 8-N-1 (8 data bits, no parity, 1 stop bit), no flow control, Echo Mode OFF
Serial Port 2: 9600 baud, 8-N-1 (8 data bits, no parity, 1 stop bit), no flow control, Echo Mode OFF
Serial Port 3: 9600 baud, 8-N-1 (8 data bits, no parity, 1 stop bit), no flow control, Echo Mode OFF
Serial Port 4: 9600 baud, 8-N-1 (8 data bits, no parity, 1 stop bit), no flow control, Echo Mode OFF
Auto-Execute 1: Timeout Period 255 units (1 unit = 128 seconds), Reset Mode = ON
Auto-Execute 2: Timeout Period 255 units (1 unit = 128 seconds), Reset Mode = ON
Start-up Active Device: 6
XFER Delay (min): 0 ms