Fulgor Milano FWC 4524 TC - Manual (Page 28)

28 29
GB
TEMPERATURE SETTING
For Single Zone
• The temperature setting range is 5-22 ºC (41-72 ºF).
• Directly touch the
or mark to set the wine cooler temperature as you want.
• The first touch on or mark will recall the previous set temperature displayed in the digital
window. If the appliance runs after a power failure (or unplugging), the previous set temperature
does not exist and is replaced by the defaulted temperature at 12ºC.
• Touch the mark to increase the set temperature by 1ºC. On the contrary, touch the mark to
decrease the set temperature by 1ºC.
• The digital will change to display the real temperature of the inside cabinet after 10 seconds
without being touched.
Note: For the first time to use the appliance or to restart the appliance after having been shut off for
a long time, you may find a few degrees variance between the set temperature and the displayed
temperature. It is normal and everything of the appliance will be in the order after a few hours running
SELECTING FAHRENHEIT(ºF) & CELSIUS (ºC) DISPLAY
For Single Zone
Touch the marks with 2 fingers at the same time and hold for 5 seconds, you can interchange
the Fahrenheit and Celsius display.
For Dual Zone
Directly touch the mark , you can interchange the Fahrenheit and Celsius display for both zones at
the same time.
CARE AND MAINTENANCE
CLEANING THE WINE COOLER
• Turn off the power, unplug the appliance, and remove all items.
• Wipe the inside surfaces with a sponge and baking soda solution. The solution should be about 2
tablespoons of baking soda to a quart (approx. 1 litre) of warm water.
• Wash the shelves with a mild detergent solution. Allow wooden shelves to dry.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical
parts.
• Wipe the outside cabinet with warm water and mild liquid detergent. Wipe dry with a clean soft
cloth.
• Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.