Fulgor Milano FDW9017 - Manual (Page 52)

The hose must always discharge at least 350 mm above the bottom
of the machine.
Ensure that the drainage hose has no kinks.
NOTE!
The hose must be attached at the same height as the underside
of the sink.
CONNECTION TO WATER SUPPLY
Use only the supply hose provided with the dishwasher. Do not
re-use old hoses or other spare supply hoses.
The supply pipe must be fitted with a stopcock. The stopcock must
be easily accessible, so that the water can be shut off if the
dishwasher has to be moved.
Once the installation is complete, the stopcock should be opened
to allow the pressure to settle for a while and to check that all
connections are tight.
Connect to cold water...
If you use oil or electricity to heat your home.
Connect to hot water (max. 70 °C)...
If you use district heating, solar power or geothermal power to
heat your home. Choosing a hot water connection cuts programme
times and reduces the dishwasher's electricity consumption.
ELECTRICAL CONNECTION
Information about the electrical connection can be found on the
serial number plate This specification must match the electricity
supply.
Dishwashers fitted with a plug must be connected to an earthed
socket.
The electric wall socket must be placed outside of the installation
area to be easily accessible after installing the dishwasher. Do not
use an extension cord!
NOTE!
Repairs and maintenance relating to safety or performance must
be carried out by a qualified professional.
SERVICE
Read the chapter Troubleshooting before contacting the service
division. Make a note of the information on the serial number plate
on the right inside the dishwasher. Note the type number (1) and
the serial number (2).
SERIAL NO
TYPE
1
2
24