GAMMA 5003 STRINGING MACHINE (Issue 3 - December 14, 2000) - Manual (Page 7)

6
ASSEMBLY INSTRUCTIONS
Installing the Frame Support Posts
The GAMMA 5003 support post assemblies are preci-
sion aligned at the factory and are marked for proper
installation on the turntable.
Install the support post with the dot on its base to an
identical dot on the turntable. Align the threaded hole in
the bottom of the frame support post with the slot in the
turntable. Screw the lever lock bolt with washer into the
bottom of the support post and tighten gently.Position
the washer with the rounded edge toward the turntable.
Repeat procedure on the opposite side of the turntable.
Installing the Turntable
Insert the center post of the turntable into the bushing
located in the top of the tensioner bar post.
Locking the Turntable
The turntable may be locked in any position.
The turntable winged lock knob is packed separately in
the accessory polybag. Install the lock knob into the
threaded hole located on the side of the tensioner bar
post.
Rotate the knob clockwise to lock the turntable, and
counter-clockwise to release the turntable.