Desa HCA-24-RFN - Manual (Page 9)

www.desatech.com 115481-01A 9
3. Place fiber log pieces randomly on lava rock and
ember material around unit (see Figure 10).
4. Use remaining lava rock to blend the floor
media together. Your finished effect should
resemble Figure 11.
WARNING: Failure to posi-
tion the floor media as shown in
Figures 8 through 11 or failure
to use only parts specifically
approved with this appliance
may result in property damage
or personal injury.
INSTALLATION
Continued
Figure 8 - Placing Lava Rock
Figure 9 - Placing Ember Material
Figure 10 - Placing Fiber Log Pieces
Figure 11 - Floor Media Kits Installed
OPERATING APPLIANCE
The RF Millivolt valve control used on these appli-
ances allows you to turn the gas log set on or off; use
a timer to automatically operate the log set; increase
or decrease flame height, fan speed or timing. An
easy-to-read display gives you information about
room temperature, set temperature, flame height
level, fan speed level and a countdown timer, as
well as a low battery indication. Figure 12 shows
the location of the controls and indicators for the
transmitter (remote) and the receiver (valve).
Note:
Fan operations are not applicable to these
Hardwood Series.
Figure 12 - RF Millivolt Valve Controls
with Transmitter/Remote
Display
TRANSMITTER/REMOTE
Up Arrow
Down Arrow
Mode
Button
Timer
Button
RECEIVER/VALVE Piezo
PilotStat
Knob Manual
Switch
LED