Geist L Series - Manual (Page 4)

GM1045 Rev 2 4 Rev Date: 7/28/2014
Detachable Power Supply Cords
L Series In-Line Power Monitoring Units may optionally be configured with an AC Inlet for
connection to AC Mains power. Use only detachable power supply cords of the appropriate size
and type, as stated below, with the unit. Use only with light PVC sheathed flexible cords
(according to IEC 60227) or ordinary tough rubber-sheathed flexible cords (according to IEC
60245) that terminate in an attachment plug meeting local/national code requirements.
For Global units use a minimum 1.5 mm
2 nominal conductor cross-sectional area detachable
power supply cord with ratings of 300 V and 75 °C. The power supply cord cable designation
should be H03VV-F, H03VVH2-F, or better.
For North American units use a minimum 14 AWG power supply cord with ratings of 300 V and
75 °C. The power supply cord cable designation should be SJT or better.
EMC Verification
This Class A device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
FCC and Canadian ICES-003 requirements for units with Current Monitoring Meter: The ferrite
core shipped with the unit must be placed around the Ethernet cable close to the In-Line Meter.