Gladiator GAGD264DBG Starter Series 4-Drawer Modular GearDrawer - Manual (Page 3)

3
6. Insert 2 carriage-head bolts into the bottom panel/cabinet back
and secure with the serrated washers and hex nuts.
7. Insert 4 casters into the mounting brackets.
Remove and Replace the Shelf
Remove the Shelf
1. Remove the shelf clips from their shipping position on the sides
of the cabinet. Working from the inside of the cabinet and using a
blunt tool, push out the plastic shelf clips. Discard the clips.
2. Lift up on the underside of the shelf until the shelf tabs are free of
the cabinet slots.
3. Tilt the shelf up to reposition it within the cabinet or to remove it
from the cabinet.
Replace the Shelf
NOTE: Plan your shelf height from the bottom. The shelf is supported
by the metal tabs on the side walls of the cabinet.
1.
Determine the placement of the shelf.
2. Tilt the shelf so that one end is higher than the other as shown.
3. Insert the shelf into the cabinet so that the higher end is directly
above the desired slots and push the shelf down in place behind
the side slots.
4. Raise the lower end so it is directly above the desired slots and
push the shelf down.
NOTE: Make sure the shelf tabs are in place behind all the slots
as shown.
A. Carriage-head bolts with serrated
washers and hex nuts
B. Carriage-head bolt
C. Serrated washer
D. Caster mounting bracket
E. Hex nut
B
C
D
E
A
A. Push down.
B. Lift up.
A. Slot
B. Shelf tab
A
B
A
B