Guralp Systems CMG-CD24 - Manual (Page 70)

CMG-CD24
5.7.4 MASSES?
Syntax: MASSES?
Displays the current, instantaneous position of the three sensor
masses, in counts (range ±8 000 000):
masses? z-position n/s-position e/w-position ok
5.7.5 RE-BOOT
Syntax: RE-BOOT
Causes the CD24 to reset. Some configuration changes will only take
effect after you have rebooted the digitiser.
5.8 Flash storage and filing
5.8.1 SHOW-FLASH
Syntax: SHOW-FLASH
Reports status information about Flash memory in the CD24. For
example:
SHOW-FLASH for a new system with 8 × 64Mb chips fitted:
show-flash FILESTORE C 0000FFFF00000000
FILESTORE K 1048160
Last Flush: CHIP - -1 0000FFFF
Last write: CHIP – 35 00000FF8 ok
The first two lines display internal diagnostic information, whilst the
last two lines describe the position in Flash
•
where data was last flushed, and
•
where data was last written.
5.8.2 DOWNLOAD
Syntax: DOWNLOAD (but see below)
Sets up a data transfer from the Flash memory over the serial
connection direct to SREAM! or other software.
SCREAM! Can be configures to auto-record data. Refer to the manual
for more information.
70 Issue C