Mounting, Ts series installation – Dual TS Series User Manual

Page 5

Advertising
background image

Mounting

5

TS SERIES

 INSTALLATION

1. Determine where the speakers will

be mounted. Make sure the area
is large enough for the speaker
to mount evenly. Also ensure the
mounting location is deep enough for
the speaker to fit.

2. Refer to the specification chart to

determine the proper diameter hole
to cut for your speaker model.

3. If supplied, use the plastic mounting

ring as a template to mark the
locations for the mounting screws.
Drill the holes with a 3/32" bit.

4. Be sure to observe proper polarity

when connecting the wires. The
speaker's positive terminal is
indicated with a "+" symbol.

5. Fit the speaker to the hole cut-out.
Mount the speaker using the

supplied screws. If the speaker grill
is to be used, insert 4 screws into
the grill holes and then mount the
speaker.

Standard Rear Deck Installation

Mounting hole

Cut-out

Grille

Speaker

Standard Door Installation

Grille

Speaker

Mounting hole

Cut-out

Advertising
This manual is related to the following products: