Harken 7410.11 MKIV Jib Reefing & Furling - Manual (Page 28)

28 MKIV Underdeck Unit 0
Commissioning Lead Line to Cockpit
Feed the line through bullseye and into spool. Run down into deadend hole located on the lower flange of
the spool and add a stop knot. Tie an overhand or figure-8 knot in the end. Set up lead block so line runs
perpendicular to drum when it leaves bullseye.
The bullseye can correct small differences in line angle. Lead line aft using ball bearing blocks where line
makes a turn more than 30 degrees. Install cleat.
2
1
1. Run line out of hole in bottom of spool
and tie a single overhand knot.
2. Pull knot back up to seat at hole.
Rotate the drum clockwise to charge the spool. Wind 10–15 ft (3–4.5 m) of line on spool.
Deadend Hole
IMPORTANT! Make sure that the suncover, if used, is installed on the starboard side of the sail.