Harken 3867 System C CB Battcars: built 2008 to present - Manual (Page 7)

System C CB 7
1. Slip top track slugs into mast groove.
Use 51 mm (2") mounting slug for top stop.
Short top track lengths
Top slug
54 mm (2 1 /
8
") 105 mm (4 1 /
8
")
81 mm (3 3 /
16
") 25 mm (1")
Install 76 mm (3") connector slug at bottom.
Mast up: Tape 51 mm (2") slug even with
top of upper track. Tape other slugs in place.
2. One drop blue Loctite ® adhesive into
each connector slug hole.
3. Thread a 8 x 40 mm screw through
endstop, track, and into endstop slug.
Short top track lengths
54 mm (2
1 /
8
") Use one screw in stop.
81 mm (3 3 /
16
") Use both screws.
Mast up: Remove tape. Tighten screw
to hold track.
4. Slide slugs into place with putty knife.
Loosely install 8 x 25 mm screws.
Tip: Use putty knife to see if screws
are loose enough to slide in groove.
Remember: Tracks may stick when
reaching a spliced area on mast.
5. Loosen top screw. Slide top track up
and position next 2.08 m (6'9 15 /
16
") track.
Mast up: Tighten bottom screw to
hold track.
6. Slide 19 mounting slugs and connector
slug into mast groove.
Mast up: Tape in place.
Put one drop blue Loctite into each hole.
Assembly Install Track
Loctite is a registered trademark of Henkel AG & Company KGaA.