DeWalt DW706 - Manual (Page 7)

5
English
FIG. 2
GUARD
RIGHT SIDE
FENCE
MITER
CLAMP
KNOB
MITER
LATCH
MITER
SCALE
BENCH MOUNTING
HOLES
LEFT SIDE FENCE
CLAMPING KNOB
LOCK DOWN
PIN
OPERATING HANDLE
BEVEL SCALE
FIG. 4
TRIGGER
SWITCH
OPERATING
HANDLE
LEFT SIDE
FENCE
MOTOR
HOUSING
45˚ BEVEL
OVERRIDE
LEVERS
DUST
SPOUT
MOTOR END
CAP
0˚ BEVEL
OVERRIDE
KNOB
LOCK DOWN
PIN
BEVEL STOP–
33.85˚ PAWLS
CARRY HANDLE
BLADE
WRENCH
45˚
BEVEL STOP–
ADJUSTMENT
SCREW
BEVEL
LOCK
KNOB
HAND
INDENTATIONS
0˚ BEVEL STOP
ADJ. SCREW
(25.4mm) diameter blade hole] and against the inner
clamp washer with the teeth at the bottom of the blade
pointing toward the back of the saw.
3. Assemble the outer clamp washer onto the spindle.
4. Install the blade screw and, engaging the spindle lock,
tighten the screw firmly with wrench provided. (Turn
counterclockwise, left-hand threads)
NOTE: When using blades with a 5/8" (15.88mm) diameter
blade hole, the blade adapter will not be used and should be
stored in a safe place for future use.
5. Return the guard bracket to its original position and
firmly tighten the guard bracket screw to hold bracket in
place.
WARNING:
• The guard bracket must be returned to
its original position and the screw tight-
ened before activating the saw.
• Failure to do so may allow the guard to
contact the spinning saw blade result-
ing in damage to the saw and severe
personal injury.
Transporting the Saw
TURN OFF AND UNPLUG THE MITER SAW BEFORE
ATTEMPTING TO MOVE IT OR MAKE ANY ADJUST-
MENTS WHAT SO EVER!
In order to conveniently carry the miter saw from place to
place, a carrying handle has been included on the top of the
saw arm and hand indentations in the base, as shown in
Figure 4.