Harken 35.2ST Winche - Manual (Page 5)

5 Radial Winch 35.2 ST Installation and Maintenance Manual
The winch can be installed following one of the two procedures below ( Procedure1 or Procedure2):
Procedure1
To install the winch you must remove the drum and use Socket Head (SH) bolts.
Tools needed One medium flat-bladed screwdriver
To identify the various parts, refer to the exploded view at the end of this Manual.
Torque to apply when assembling
1. Unscrew the central screw ( 2Nm/18 in-lb) 2. Slide off the assy socket n°28 and the cover
n°29
3. Unscrew the three screws n°27
( 4Nm/35 in-lb)
4. Remove the self-tailing arm n°26 by rotating
and lifting it.