Denon DVD-3910 - Manual (Page 14)

14
ENGLISH
6 REMOTE CONTROL UNIT
2 The DVD-3910 can be controlled from a distance using the included remote control unit (RC-972).
(1) Inserting Batteries
q Remove the remote control unit’s rear cover.
w Place two R6P/AA batteries in the battery
compartment in the direction indicated by the
marks.
e Close the rear cover.
Cautions On Batteries
• Use R6P/AA batteries in this remote control unit.
• Replace the batteries with new ones approximately
once a year, though this depends on the frequency
with which the remote control unit is used.
• If the remote control unit does not operate from
close to the main unit, replace the batteries with
new ones, even if less than a year has passed.
• The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do
so in the proper direction, following the < and
>
marks in the remote control unit’s battery
compartment.
• To prevent damage or battery fluid leakage:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or
dispose of batteries in flames.
• Remove the batteries when not planning to use
the remote control unit for a long period of time.
• If the batteries should leak, carefully wipe off the
fluid from the inside of the battery compartment,
then insert new batteries.
(2) Using the Remote Control Unit
SEL ECT HDM I/D VI OPE N/ CD/S TER EO
FOR MAT NTSC /PAL CLO SE /M ULT I PR OG /DIR CLE AR CAL L SEA RCH MODE AU DIO SUB TITLE AN GLE
PA GE MAR KER RAN DO M DIM ME R ZOO M PICT ADJ . SETU P MEM ORY
A-B REPE AT
SELE CT RC-972
PUR E DIR ECT
DISP LAY
TOP MEN U
RETUR N
MEN U
SKI P SLOW /SE ARC H PLA Y STILL /PAU SE STOP
BAC K LIGH T
PO WER OFF
POW ER O N
Approx. 7 meters
• When operating the remote control unit,
point it at the remote control sensor as
shown on the diagram.
• The remote control unit can be used from a
direct distance of approximately 7 meters.
This distance will be shorter, however, if
there are obstacles in the way or if the
remote control unit is not pointed directly
at the remote control sensor.
• The remote control unit can be operated at
a horizontal angle of up to 30° with respect
to the remote control sensor.
NOTES:
• It may be difficult to operate the remote
control unit if the remote control sensor is
exposed to direct sunlight or strong
artificial light.
• Do not press buttons on the main unit and
on the remote control unit at the same
time. Doing so will result in malfunction.
SELECT
HDMI/DVI OPEN/
SUPER AUDIO
FORMAT NTSC/PAL CLOSE
CD SETUP
PROGRAM /DIRECT
CLEAR
CALL SEARCH MODE
AUDIO SUBTITLE ANGLE
PAGE
MARKER RANDOM DIMMER ZOOM
PICTURE
ADJUST SETUP MEMORY
A-B REPEAT
SELECT PURE DIRECT
DISPLAY TOP MENU
RETURN MENU
SKIP SLOW/SEARCH
PLAY STILL/PAUSE STOP
BACK LIGHT
POWER OFF POWER ON q
@1
@2
@3
@5
@7
@8
@9
#0
#1
#3
#2
#4
@0
@4
@6
!8
!9
w
e
r
u
i
o
!2
!3
!5
!7
!4
!6
!1
!0
y
t
(3) Names and Functions of Remote Control Unit Buttons
2 Button not explained here function in the same way as the corresponding buttons on the main unit.
q
POWER ON/POWER OFF buttons
• Press this to switch the power between on
and standby.
w HDMI/DVI SELECT/FORMAT buttons
• Use these to select to use HDMI terminal or
DVI terminal, and the format of video signals
(480P/576P,720P,1080i).
e Number buttons
• Use these to input numbers.
Use the +10 button to input numbers of 10 or
over.
Example: To input 25
r LIGHT button
• Press this to light the opal color button.
Press again this to put out light.
t
ANGLE button
• Press this to switch the angle.
y TOP MENU button
• The top menu stored on the disc is displayed.
u Cursor buttons/ENTER button
• Use the • and ª cursor buttons to select in
the vertical direction.
Use the
0 and 1 cursor buttons to select in
the horizontal direction.
Press the ENTER button to select the item
selected with the cursor buttons.
i MENU button
• The DVD menu stored on the disc is
displayed.
o STOP button ( 2 )
!0 STILL/PAUSE button ( 3 )
!1 SKIP buttons
!2 REPEAT button
• Press this to play tracks repeatedly.
!3 A-B repeat button (A-B)
• Use this to repeat sections between two
specific points.
!4
RANDOM button
• Press this to play the tracks on the video or
music CD in random order.
!5 MARKER button
• Press this to mark places you want to see
again.
!6
SETUP button
• Press this to display the default setting
screen.
!7 PICTURE ADJUST button
• Press this to adjust the picture quality to suit
your tastes.
!8
OPEN/CLOSE button
!9 NTSC/PAL button
• Use this to switch the set’s video output
format (NTSC/PAL).
@0
SUPER AUDIO CD SETUP button
@1 PROGRAM/DIRECT button
• Press this to switch between the normal play,
programmed play.
@2
CLEAR button
• Press this to clear numbers that you have
input.
@3 CALL button
• Press this to check the program contents.
@4 SEARCH MODE button
• Press this to change the search mode to search for
groups or titles, tracks or chapters when selecting
sections of discs directly using the number buttons.
@5 AUDIO button
• For DVDs, press this to switch the audio
language. For video CDs, press this to switch
the channel between “STEREO”, “MONO
LEFT” and “MONO RIGHT”.
@6 SUBTITLE button
• Press this to switch the DVD’s subtitle
language.
@7
DISPLAY button
• Press this to display the ON-SCREEN.
@8 RETURN button
• Press this to return to the previous menu
screen.
@9
PLAY button ( 1 )
30°
30°