HONDA 2011 Civic Hybrid - Manual (Page 302)

Open the trunk. Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
Remove the bulb from the socket
by pushing the bulb in and turning
it counterclockwise until it unlocks.
Install the new bulb in the socket.
Turn it clockwise to lock it in place.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Reinstall the inner fender cover.
Then reinstall the holding clips,
and lock them in place by pushing
on their centers.
Turn on the lights to make sure
the new bulb is working.
Remove the bulb from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Use the flat-tip screwdriver to
remove the screws in the center of
each fastener on the side of the
trunk lining. Remove the fasteners
first, then pull the lining back
carefully.
Determine which of the four bulbs
is burned out: stop/taillight,
back-up light, side marker light, or
turn signal light.
1.
4.
5.
6.
7.
8.
3.
2.
2.
Replacing Rear Bulbs
(In Fenders)
Lights
296
FASTENER
BULB
SOCKET
FASTENER
10/06/24 20:15:42 31SNC650_301