HONDA 2010 Civic Hybrid - Manual (Page 116)

−
− −
−
−
CONTINUED
If you do nothing, the system will
then scan for the next strong station
and play it for 10 seconds. When it
plays a station you want to listen to,
press the SCAN button again. Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
The seek function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
or side of the
SEEK bar, then release it.
Each side of the buttons
(1 through 6) can store one
frequency on AM, and two
frequencies on FM.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
Pick a preset number (1 6), and
hold it until you hear a beep.
Use the tune, seek, or scan
function to tune the radio to a
desired station.
Select the desired band, AM or
FM. FM1 and FM2 let you store
six stations each.
You can use any of five methods to
find radio stations on the selected
band:
the
preset buttons, and .
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Turn the system on by
pushing the PWR/VOL knob or the
AM/FM button. Adjust the volume
by turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
The scan function samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When it finds a strong signal, it will
stop and play that station for about
10 seconds.
1.
2.
3.
4.
To Select a Station
TUNE
SEEK Preset
To Play the AM/FM Radio
TUNE, SEEK, SCAN,
AUTO SELECT
SCAN
Playing the AM/FM Radio (Models without navigation system)
Fe
a
tu
re
s
113
09/07/15 10:44:51 31SNC640_118
2010 Civic Hybrid