Hypertherm THC Plasma Interfacer Upgrade - Manual (Page 9)

Page 8 128503 Kit Instructions
command THC Plasma Interface Upgrade
14. Put the Command THC in MANUAL MODE.
15. Begin a cutting process and compare the voltage displayed on the volt meter to the arc voltage
displayed on the CNC or THC pendant.
17. Turn off power to power supply and to THC system.
18. Remove volt meter from the plasma interface assembly.
19 Install the access cover to the
THC plasma interface assembly
and the control module.
IM380.07
16 Adjust the potentiometer on the PC board so that the
voltage displayed on the volt meter is the same as the arc
voltage displayed on the CNC or THC pendant.
IM380.08