Daily, Do a test of the inlet pressures, Examine all of the air filters – Hypertherm HPR130 Auto Gas Preventive Maintenance Program User Manual
Page 11
Advertising
HPR130 Auto Gas Instruction Manual 808580
11
Preventive Maintenance Program
Daily
Do a test of the inlet pressures
1. With the gas flowing in test preflow mode, make sure that the pressure at the
regulator is set to 8 bar (115 psi).
2. Repeat the test in cutflow mode, and make sure that the regulator is set to 8 bar
(115 psi).
For instructions about setting supply regulators, see
Setting the supply
regulators in your system’s instruction manual.
Examine all of the air filters
Examine the compressed air filter system.
1
Advertising
This manual is related to the following products: