Ata/ide configuration, Configure sata as, Bios setup 22 – IBASE MI890 User Manual
Page 26: Mi890 user’s manual, 1) disabled. (2) compatible. (3) enhanced, 1) ide mode. (2) ahci mode
BIOS SETUP
22
MI890 User’s Manual
BIOS SETUP UTILITY
Advanced
IDE Configuration
Options
Disabled
Compatible
Enhanced
<-
Select Screen
↑↓
Select Item
+-
Change Option
F1
General Help
F10 Save and Exit
ESC Exit
ATA/IDE Configuration
[Enhanced]
Configure SATA as
[IDE]
►
Primary IDE Master
: [Not Detected]
►
Primary IDE Slave
: [Not Detected]
►
Secondary IDE Master
: [Not Detected]
►
Secondary IDE Slave
: [Not Detected]
►
Third IDE Master
: [Not Detected]
►
Third IDE Slave
: [Not Detected]
►
Fourth IDE Master
: [Not Detected]
►
Fourth IDE Slave
: [Not Detected]
Hard Disk Write Protect
[Disabled]
IDE Detect Time Out (Sec)
[35]
ATA(PI) 80Pin Cable Detection
[Host & Device]
The IDE Configuration menu is used to change and/or set the configuration of the
IDE devices installed in the system.
ATA/IDE Configuration
(1) Disabled.
(2) Compatible.
(3) Enhanced
Configure SATA as
(1) IDE Mode.
(2) AHCI Mode.
BIOS SETUP UTILITY
Advanced
Configure Win627UHG Super IO Chipset
Allows BIOS to Select
Serial Port Base
Addresses
<-
Select Screen
↑↓
Select Item
+-
Change Option
F1
General Help
F10 Save and Exit
ESC Exit
Serial Port1 Address
[3F8/IRQ4]
Serial Port2 Address
[2F8/IRQ3]
Serial Port3 Address
[3E8]
Serial PortC IRQ
[IRQ11]
Serial Port4 Address
[2E8]
Serial PortD IRQ
[IRQ10]
Restore on AC Power Loss
COM1 RS485 Auto Flow Contorl
[Power Off]
[Disabled]