IBASE IB905 - Manual (Page 20)

INSTALLATIONS
16 IB905 User’s Manual
J10, J13: LVDS1, LVDS2 Connectors (1st/2nd channel)
Signal Name Pin # Pin # Signal Name
TX0- 2 1 TX0+
Ground 4 3 Ground
TX1- 6 5 TX1+
*5V/3.3V 8 7 Ground
TX3- 10 9 TX3+
TX2- 12 11 TX2+
Ground 14 13 Ground
TXC- 16 15 TXC+
*5V/3.3V 18 17 ENABKL
+12V 20 19 +12V
* Remarks: These connectors support 24-bit.J10 is 1st channel. J13 is 2nd
channel. J7 can be used to set 1-2 3.3V or 2-3 5V.
J6: LCD Backlight Connector (DC type)
Pin # Signal Name
1 +12V
2 Backlight
Enable
3 *Backlight Adj
(DC type)
4 Ground
* LCD backlight brightness can be adjusted by the OS or in the BIOS setup. In the
BIOS setup, both backlight enable/disable and backlight brightness can be
configured. Also, the backlight voltage can be set to 3.3V or 5V.
JP7: COM1, COM2 Serial Port (DF11 Connector)
Signal Name Pin # Pin # Signal Name
DSR1
Data set ready
2 1 DCD1
Data carrier detect
RTS1
Request to send
4 3 RXD1
Receive data
CTS1
Clear to send
6 5 TXD1
Transmit data
RI1
Ringing indicator
8 7 DTR1
Data terminal ready
Not used 10 9 Ground
DSR2 12 11 DCD2
RTS2 14 13 RXD2
CTS2 16 15 TXD2
RI2 18 17 DTR2
Not used 20 19 Ground