IBASE IB950 - Manual (Page 12)

INSTALLATIONS
8 IB950 User’s Manual
Setting the Jumpers
Jumpers are used on IB950 to select various settings and features
according to your needs and applications. Contact your supplier if you
have doubts about the best configuration for your needs. The following
lists the connectors on IB950 and their respective functions.
Jumper Locations on IB950 ................................................................... 9
JBAT1: Clear CMOS Setting............................................................... 10
JP1: CompactFlash Slave/Master Selection ......................................... 10
JP3: PCI Riser Card Selection ............................................................. 10
JP4, JP6, JP8, JP10: Serial Port RI_pin V-out Selection ..................... 10
JP5, JP7, JP9: RS232/422/485 (COM2) Selection .............................. 11
JP11: AT/ATX power on type Selection ............................................ 11
JP12: LCD Panel Power Selection ....................................................... 11
IMPORTANT NOTE: When the system boots without the CRT being
connected, there will be no image on screen when you insert the
CRT/VGA cable. To show the image on screen, the hotkey
(CTRL-ALT-F1) must be pressed.