IBASE SI-102-N - Manual (Page 19)

Copyright © 2013 IBASE Technology Inc. All Rights Reserved.
17 IBASE Technology Inc.
CHAPTER 2 MOTHERBOARD INTRODUCTION
2.1 Installing the Memory
The IB923 board supports one DDR3 memory socket J6 for a maximum total memory
of 8GB DDR3 memory type.
Installing and Removing Memory Modules
To install the DDR3 modules, locate the memory slot on the board and perform the
following steps:
1. Hold the DDR3 module so that the key of the DDR3 module aligned with that on
the memory slot.
2. Gently push the DDR3 module in an upright position until the clips of the slot close
to hold the DDR3 module in place when the DDR3 module touches the bottom of
the slot.
3. To remove the DDR3 module, press the clips with both hands.