ikan IDX-1204 - Manual (Page 6)

ikan Corporation
IDX-1204 [EUM-A]
5
Chapter 2. IDX-1204 operation
2-1 Scene Setting
STEP-1 Press【 SC / CH】to select the control channel
LED : off in CH mode
LED : on in SC mode
STEP-2 Move【 MASTER-VR】to the top
STEP-3 Move【 VR-1 … VR-12】to dimming
STEP-4 Press【 PROG】+【1…12】to confirm and save the selection
2-2 Scene Recall
A: 0%…100% VR control
STEP-1 Press【 SC / CH】key to select【SC】mode. (LED ”on”)
STEP-2 Slide the desired VR Channel down (dimming) to recall the
scene of the same Channel
【
VR-1…VR-12】
Ex : to recall SC-2, adjust the【VR-2】, to recall scene 2 by dimming
B: FLASH
STEP-1 Press【 SC / CH】to select【SC】mode. (LED ”on”)
STEP-2 Press Channel button (underneath dimmer control) to select that Channel
EX : to recall SCENE 2, press and slide VR2 to 100%. 【
2】
Select【CH】mode, and move the fader to set the dimming value
Press【PROG】+【1~12】 to save control scene.
1.) When MASTER-VR is set to 100% and the selected VR Channel is dimmed
to 50%, the SCENE total output will be reduced to 50%.
2.) When MASTER-VR is set to 50% and the selected VR Channel is dimmed to
50%, the SCENE total output will be reduced to 25%.
Use the following information to recall the scene. For instructions on setting the
dimming properties o fVR1 through VR12, refer to Section 2-1: Scene Setting.