ikan JIB-01C - Manual (Page 9)

When using a Fluid head option
you will need to add appropriate
counterweight to compensate for
its weight. You may also use the
provided weight bag as an
additional counterweight and dial
in exactly the amount of weight
required for your particular
Below is a guide to help dial in potential
balancing scenarios:
Attach the counterweights to balance the approximate
payload . Once the camera is attached with the counter-
weights added, fine tune the balance by sliding the tail
section in or out. When the jib is level (parallel to the
ground), it should float.
When using the traditional camera release
plate you will be operating from the rear of
the Jib and will likely require a monitor.
There are ¼” – 20 thread mounting points
at the base of the jib to achieve this. This
configuration is better for wide sweeping
shots.