Inova Labs XYC100B-SPT Quick Start - Manual (Page 6)

1. Press and hold the Power Button
until you hear a short beep and see
all LEDs briefly illuminate. Allow 3
minutes for the unit to warm-up.
CAUTION: DO NOT place the
cannula in your nose until the unit is
fully powered on. Breathing through
the cannula during start-up may
prevent the system from powering on.
2. Press the Pulse Setting (1, 2 or
3 LPMeq) prescribed by your
doctor. The green LED above the
selected setting will illuminate and
flash each time a breath is detected.
OPERATING YOUR LIFECHOICE ACTIVOX POC
Follow the steps below to power on and operate your unit.
6