JLCooper FaderMaster Pro - Manual (Page 19)

Programming FaderMaster Pro
Programming is done one of the programming modes,
accessed by simply pressing the PROG button.
First, before attempting to make any changes to the way
FaderMaster Pro is programmed,
Make sure that the PROTECT feature is OFF
.
(The PROTECT feature works like the safety tab on a cassette
or diskette, to prevent you from accidentally changing the
memory of FaderMaster Pro.)
Hold SHIFT and PROTECT observe the Protect status.
Move any fader to turn Protect on and off.
When Protect is off, the display indicates
0FF.
When Protect is on, the display indicates Pro.
Entering Programming Modes:
To program the faders,
press the PROG button once so that the FADER LED is lit.
To program the buttons,
press the PROG button again so that the BUTTON LED is lit.
To program the foot pedal input,
press the PROG button again so that the FADER LED flashes.
To program the foot switch input,
press the PROG button again so the BUTTON LED flashes.
Exiting Programming Modes:
To exit the programming mode,
press the PROG button again until both LEDs are off.
19