JLCooper FaderMaster Pro - Manual (Page 8)

Buttons Above the Faders
When one of the P Banks has been selected on FaderMaster
Pro, pressing a button sends any kind of MIDI command.
When one of the A Banks has been selected on FaderMaster
Pro, pressing these buttons send MIDI Controller commands
with a zero value to act as audio Mutes.
Also in the A Banks, press these buttons to Enable a fader to
send MIDI Controller commands.
When in one of the Program Modes (selected by the PROG
button), the buttons above the faders are used for assigning the
kind of MIDI command (parameter) that a given control will
send, certain other attributes of the fader. The kinds of
parameters and attributes selected by the buttons are as
follows:
PARM
In Program mode, hold PARM while moving a fader to select
the parameter, that is, the type of MIDI Command, that a
control will send.
Choices include: Notes, Controllers, Program Change, Pitch
Bend, and After touch.
CHAN
In Program mode, hold CHAN while moving a fader to select
the MIDI channel, 1 through 16, that a control will send.
PARM#
In Program mode, hold PARM# while moving a fader to select
the parameter number, that is, the Controller number or Note
number, that the control will send.
8