D-Link DI-524UP - Manual (Page 50)

46
Upstream Bandwidth
Use the pull-down menu to set the Upstream Bandwidth. The
user may choose a speed from 64kbps to Full (100Mbps).
Ensure that the bandwidth does not exceed the incoming
bandwidth from the ISP or it will cause other devices on the
LAN to slow down due to decreased bandwidth. Check with
your ISP for more information on the bandwidth allotted to your
account.
QoS Control by IP Click the enabled radio button to enable QoS priority by MAC
address. Information coming from this IP address will have the
highest priority on the LAN. This means that information
originating from this device will be sent to other devices on the
LAN requesting it, first. Other devices will have a lower priority
in sending information through the router.
Source IP Address Enter the source IP address or range of IP addresses that will
be set for high priority QoS in the router.
Reserved Bandwidth Use the pull-down menu to select the best bandwidth for the
QoS setting on this router. The user may set a Bandwidth
between 1Kbps to 32Mbps. Choosing Best Effort will set the
router to allow the first user to access the source IP address to
have the total bandwidth needed for the file being transferred.
Choosing Full will denote that the router will allot 100Mbps of
bandwidth for the specified QoS implementation. Only one QoS
implementation can be set at Full.
Click Apply to set the QoS for IP .