Kemppi Promig 200 ML - Manual (Page 10)

PROMIG 200ML/0520 – 10 © KEMPPI OY
1
0
1
0
Main switch
When the switch is in position1 the unit is ready for welding. In position 0
the machine gets no voltage and power source or wire feed motor cannot
not be started. In MIG/MAG welding the wire drive switch is working.
Welding process selection switch
MMA welding with stepless welding current control
MIG two-sequence procedure (normal function)
MIG four-sequence procedure (hold switch)
MIG-process selection switch
Pulsed MIG
Synergic MIG (1-MIG)
Normal MIG
Control mode selection switch
Local control
Remote control
Wire feed speed and current control
MIG/MAG welding: local control of wire feed speed
MMA welding: welding current control.
ML-function panel