Kemppi MagTrac F 61 - Manual (Page 8)

EN
Adjust the position of the carriage against the wall:
1. If necessary, change the position of the welding gun mechanism on the carriage by
opening the two hex screws (see the picture).
2. Adjust the position of the carriage so that it slightly pushes against the wall when
moving. To accomplish this, set the guide roller arms so that the front arm is a little
shorter than the back arm.
1.
2.
Adjust the welding gun position:
1. Loosen the orange handles (1 and 2) and make approximate adjustment of the welding
gun position.
NOTE! You can use the adjustment handle like a ratchet wrench by lifting the handle and
turning it to a better position.
2. To fine adjust the gun position, change the distance and height of the welding gun with
the adjustment knobs (see the picture).
NOTE! You can use the fine adjustment knobs also when the carriage is moving.
MagTrac F 61
6