Standard Horizon HX-870 - Manual (Page 120)

Page 120 HX870
17 MAINTENANCE
The inherent quality of the solid-state components used in this transceiver will
provide many years of continuous use. Taking the following precautions will
prevent damage to the transceiver.
• Never key the microphone unless an antenna or suitable dummy load is
connected to the transceiver.
• Use only STANDARD HORIZON approved accessories and replacement
parts.
In the unlikely event of serious problems, please contact your Dealer or our
repair facility. Address and phone numbers for this facility, as well as warranty
information, are contained in section “ 19 WARRANTY”.
17.1 REPLACEMENT PARTS
Occasionally an owner needs a replacement mounting bracket or knob.
These can be ordered from our Parts Department by emailing
[email protected] or calling:
Marine Division of YAESU U.S.A.
6125 Phyllis Drive, Cypress, California 90630
Telephone (714) 827-7600
Commonly requested parts, and their part numbers are listed below.
• SBH-12 Charger Cradle: CB6458001
• CAT460 Antenna: AY139X001
• Belt Clip (CLIP-22): CP9672002
• MIC/SP Plastic Cap: RA108700B
• MIC/SP Cap O-Ring: RA046760A
• MIC/SP Rubber: RA1555900