Denso BHT-7000 - Manual (Page 123)

107
Chapter 4. Error Messages
No execution
program selected.
Contact your
administrator.
Resume failure!
Program restarts
automatically.
Execution program not selected
■ Problem
No user program has been selected as an execu-
tion program to be run when the power is turned
on.
If this error occurs, the BHT-7000 beeps five
times (for 0.1 second per beep) and then turns
itself off.
■ Solution
Run System Mode and select an execution pro-
gram in the SET SYSTEM menu. (For the selecting
procedure, refer to Chapter 2, Subsection 2.6.3,
[4.1].)
Resume data saving error
■ Problem
When the power was turned off, the system failed
to save resume data although the resume function
had been set to ON.
The BHT-7000 displays this error message for
three seconds and automatically runs the
execution program from the point of start-up.