KIP KIPFold 1000 - Manual (Page 14)

14
Error Code List
ERROR
Example
Fan: 22 02
Cross: 00 00
RFU: 00 00
Rot.Unit: 00 00
Stacker: 00 00
Code Fan folder error Cause
21 Error on stepper control board
01 error during start stepper control board
•
38V lost on board (green led on
stepper control board is off)
•
internal logic error
02 error during stop stepper control board
22
00 Light barrier 0 cut
•
Paper between LB and prism
•
cable broken
•
Light barrier defective
01 Light barrier 1 cut
02 Light barrier 2 cut
03 Light barrier 3 cut
04 Light barrier 4 cut
23 permanent light on the receiver
00 receiver from LB 0 is always on high level
•
Direct reflection from sender to re-
ceiver
•
dust on sender, receiver or prism
•
Port on PCB damaged
01 receiver from LB 1 is always on high level
02 receiver from LB 2 is always on high level
03 receiver from LB 3 is always on high level
04 receiver from LB 4 is always on high level
24 processing error for stepper control board
01 error during calculate the step width •
mostly electrostatic
•
developer tool 02 error during counting the steps
25 Hardware error
01 lack of 5 Volt external •
Check fuses and connectors
•
fan folder: top cover open
•
cross folder: door open
02 lack of LF 38 Volt or CF door open
03 ff cover open
26 Jam
01 after cut - no signal for ready
•
Jam on the printer’s knife
02 after cut - no paper on LB 1 •
Jam on the bridge
03 without cut signal no paper on LB 1
•
Jam on the bridge
04 between LB 0 and LB 1 •
Jam in the fan folder
05 not paper end on LB 1 •
Jam in the fan folder
06 too many folds
•
copy too long
07 no end of paper on LB 0
•
Jam at output fan folder
08 Unexpected Paper on LB4 in Online-Mode
•
Switch to offline mode
09
Unexpected Paper on “no fold” switch (LB5)
in Online-Mode
27 wrong direction at last sheet folding
•
defective LB