KIP 9900 User Manual
Kip 9900 user guide
Advertising
Table of contents
Document Outline
- KIP 9900 Hardware Operation Guide
- Safety Warning
- Chapter 1 Before Use
- Chapter 2 Basic Operations
- 2. 1 Turning on the KIP 9900
- 2. 2 Turning off the KIP 9900
- 2. 3 Setting the Roll Media into Roll Deck
- 2. 4 Setting Cut Sheet Media to Bypass Feeder
- 2. 5 Replacing the Toner Cartridge
- 2. 6 Dehumidifying the Roll Media
- 2. 7 Initial Cut (Straighten the leading edge of roll media)
- 2. 8 User Mode
- 2. 8. 1 User Mode 1 (Test Print)
- 2. 8. 2 User Mode 2 (Calendar setting)
- 2. 8. 3 User Mode 3 (Warm Sleep Mode ON / OFF & timer setting)
- 2. 8. 4 User Mode 4 (Cold Sleep Mode timer setting)
- 2. 8. 5 User Mode 5 (Automatic paper cut at power ON)
- 2. 8. 6 User Mode 6 (Transfer Support LED ON/OFF [Film])
- 2. 8. 7 User Mode 7 (Alarm ON / OFF)
- 2. 8. 8 User Mode 8 (Choice of Standard / Special Print Mode [Plain paper])
- 2. 8. 9 User Mode 9 (Choice of Standard / Special Print Mode [Tracing paper])
- 2. 8.10 User Mode A (Choice of Standard / Special Print Mode [Film])
- 2. 8.11 User Mode B (Selection of Image Enhancement Mode)
- 2. 8.12 User Mode D (Cancel E-26 error)
- 2. 8.13 User Mode E (Cancel E-28 error)
- 2. 8.14 User Mode A1 (Auto Initial Cut: Media)
- 2. 8.15 User Mode A2 (Auto Initial Cut: Length)
- 2. 8.16 User Mode P1 to P4 (Special Width Selection in Metric Mode)
- 2. 8.17 User Mode F0 to Fb (Fold settings)
- Chapter 3 Error Correction and Maintenance
- 3. 1 Media Mis-feed Errors (J-**)
- 3. 1. 1 Mis-feed in Roll Decks (J-01, J-02, J-03 & J-04)
- 3. 1. 2 Mis-feed in the Bypass Feeder (J-05)
- 3. 1. 3 Mis-feed between Cutter and Drum (J-11)
- 3. 1. 4 Mis-feed on Internal Transportation Unit (J-12) and Fuser Entrance (J-13)
- 3. 1. 5 Mis-feed in Fuser Unit (J-14)
- 3. 1. 6 Mis-feed in Folder (J-21)
- 3. 1. 7 Mis-feed in Auto Stacker (J-22)
- 3. 2 Open Errors (U-**)
- 3. 2. 1 Top Drawer Open (U-01)
- 3. 2. 2 Middle Drawer Open (U-02)
- 3. 2. 3 Bottom Drawer Open (U-03)
- 3. 2. 4 Internal Transportation Unit Open (U-04)
- 3. 2. 5 Toner Cover Open (U-06)
- 3. 2. 6 Bypass Feeder Open (U-11)
- 3. 2. 7 Right Side Door Open (U-12)
- 3. 2. 8 Top Rear Cover Open (U-13)
- 3. 2. 9 Exit Cover Open (U-14)
- 3. 2.10 Folder Door Open (U-21)
- 3. 3 Toner Cartridge Error (C-01)
- 3. 4 Service Call Errors (E-**)
- 3. 5 Interruption of Print by Temperature Control
- 3. 6 Maintenance
- 3. 1 Media Mis-feed Errors (J-**)