KIP 9900 - Manual (Page 12)

Chapter 1 Before Use 1-4
1. 4 Specifications
Subject Specification
Model KIP
9900
Type Console
Printing method
LED Array Electro Photography
Photoconductor Organic Photoconductive Drum
Print speed 240mm / second (11 A0 prints / minute)
Exposure method LED Print Head
Resolution 600 x 1800dpi
Print width Maximum : 914mm (36 inches)
Minimum : 297mm (11 inches)
Print length Maximum : Plain paper 6000mm for A0/36” wide
or “5 x standard length”
Tracing paper A0 / 36 inch
Film A0 / 36 inch
Minimum : 210mm
NOTE : Longer print than the above specified maximum lengths
is available. However, KIP does not guarantee any result
including image quality and media feeding if the print is
longer than the above specified lengths.
Warm up time Shorter than 6 minutes
(At 23 degrees centigrade, 60% RH and 230V)
First print time Shorter than 18 seconds (A0)
Fusing method Heat roller fusing
Development Contact type mono component non-magnetic development system
(Initial toner is unnecessary. One toner cartridge contains 500g.)
Charging method Corona
Media feeding method Automatic (4 Roll Decks) and manual (50 cut sheets capacity)
NOTE : Multiple cut sheet feeding (50 sheets max) is available
when the size is narrower than A2 (594mm) or 24”.
Transfer method Corona
Separation method Corona and LED
Input power 220 - 240V (+6% / -10%), 16A and 50/60Hz in U.S.A. and Europe
Interface KIP Interface 8 (LVDS)
Maximum power
consumption When 230V, 50/60Hz and Dehumidify Heater is ON
Stand by
0.9 Kwh
Printing 3.0 Kwh
Warm up 3.5 Kwh
Acoustic noise Less than 70db (Printing)
NOTE : Impact noise such as cutting sound is excluded.
Less than 60db (Stand by)
Ozone Less than 0.05ppm (Average of 8 hours)
Dimensions 1360mm (Width) x 980mm (Depth) x 1265mm (Height)
Weight About 400kg
Media Specified media
Plain paper SHN
Tracing paper KMS-75
Film FA-75
(Available types)
Plain paper
70 - 90g/m 2
Tracing paper 70 - 90g/m 2
Film 100 micrometer or less in thickness