DeLonghi PAC GSR/MU - Manual (Page 10)

MAX
MIN
OFF
ON
2 3 5 7
4 6
A B C D
1
O I
10
CONTROL PANEL
“Alarm” warning light
SETTING THE TIMER
The programmer/timer, like all clocks, must be
set to the exact time. If for example it is 4:00
p.m., turn the dial in a clockwise direction
(following the direction of the arrow) until the
number 4 (4 p.m.) is lined up with the arrow
pointer (the arrows indicates 4:00 p.m.
approximately).
N.B. : Never turn the dial in an anti-clockwise
direction!
The timer is in effect, an electric clock and
works only if the plug is connected to the
power supply. Whenever the plug is
disconnected or there is a power failure, the
programmer stops (the clock is then “slow”)
and must be re-set.
The unit can be used in either programmed or
non-programmed mode.
PROGRAMMED MODE
1) Release timer button B .
2) Set the operating times by pushing out the
notches on the dial corresponding to the
period required (each notch represents 15
mins.).
3) Check that the timer indicates the correct
time (see instructions on setting).
4) Select the desired function as shown in the
chart overleaf.
The unit will now switch on and off each
day at the selected times.
N.B: To override the programmed operating
times, simply press the ON/OFF timer key.
NON-PROGRAMMED MODE
1) B TIMER button must be pressed
2) Select the desired function as shown in the
chart on the following page.
11
9
4
10
arrow pointer
11
10 9
4
Funzionamento Operating time
eg. from 9 to 11 a.m.
TIMER ON signal lamp “Fan” signal lamp
“Air-conditioning” signal lamp
Min. air-
conditioning
signal lamp
Max. air-
conditioning
signal lamp
Fan speed selection key
Fan/conditioning selection key
Timer key
ON/OFF main switch key
Thermostat knob Timer notches