DeLonghi PAC GSR/MU - Manual (Page 11)

11
HOW TO START UP THE CONDITIONER
Plug the appliance into the wall
socket.
The ON/OFF signal lamp (1) comes
on and stays on for as long as the
appliance is connected to the socket.
Select either Programmed or Non-
programmed mode (see previous
Select the fan speed required pressing
“Fan speed” key D.
Key C ( Ventilation/
Conditioning ) must
be released
Turn the thermostat to
Max. cold.
Press key A
(
ON/OFF )
Signal lamp 5
(Conditioning) and
either 6 or 7 (
Min. or
Max. fan speed ) will
come on.
The appliance comes on.
If not, refer to pag. 14.
To switch off the appliance, press key A
(ON/OFF main switch).
AIR-CONDITIONING
N.B: For technical reasons, the temperature is not shown in degrees, but is represented by two lines
which vary in thickness according to the temperature. It is advisable to begin by turning the
thermostat to the maximum setting (thick green line = maximum cooling). When the room
temperature is comfortable, turn the thermostat slowly away from the maximum heating or
cooling position until the air-conditioner switches off. Leave the thermostat in this position. The
air-conditioner is now programmed to maintain the exact temperature at all Times.
This appliance is fitted with a special safety circuit. When the compressor switches off, this
circuit prevents it from switching on again for at least 3 minutes.
N.B: the “TIMER ON” signal lamp will only come on with “Programmed” mode.
VENTILATION
Key C ( Ventilation/
Conditioning ) must
be pressed