La Crosse Technology 308-146 - Manual (Page 4)

Model: 308-146/308146W www.lacrossetechnology.com/support 4
Install Batteries in the TX142TH Transmitter
NOTE: This forecast station will come with one TX142TH transmitter OR one TX14TH transmitter.
Both transmitters work interchangeably.
1. Slide the battery cover down, then lift off the front of the TX142TH transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Confirm the channel selector switch is on channel 1.
3. Insert two new AA batteries into the transmitter.
Observe the correct polarity (see marking inside battery compartment).
4. Keep transmitter 5-10 ft. from the forecast station during setup.
5. After 15 minutes, if the outdoor temperature shows on the forecast station,
move the outdoor transmitter outside to a shaded location within range of the forecast
station.
Install Batteries in the TX14TH Transmitter
1. Slide the battery cover down, then lift off the back of the TX14TH transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Confirm the channel selector switch is on channel 1.
3. Insert two new AA batteries into the transmitter.
4. Observe the correct polarity (see marking inside battery compartment).
5. Keep transmitter 5-10 ft. from the forecast station during setup.
6. After 15 minutes, if the outdoor temperature shows on the forecast station,
move the outdoor transmitter outside to a shaded location within range of the forecast station.
LCD Screen
The LCD screen is split into 5 sections displaying the information for time, calendar, weather forecast,
indoor data, and outdoor data.