La Crosse Technology 3362 - Manual (Page 7)

7
When an electrical appliance is plugged into the Cost
Control, by pressing the “POWER” key, the
instantaneous power (Watts) being used at that precise
moment in time can be ascertained.
9.
THE MAXIMUM LOAD POWER DISPLAY:
By pressing the “POWER” key again the maximum
power load (Maximum Watts) will be displayed. This
reading applies to maximum power that an electrical
appliance has used during its monitoring period.
10. TOTAL ENERGY CONSUMPTION
DISPLAY:
By pressing the “POWER” key a third time the LCD
will show the total kWh consumed by an electrical
appliance for the monitoring period.
11. SETTING UP:
Before plugging the Cost Control into a socket and any
appliance into it the values must be set.
First enter the “TOTAL COST” display by pressing the
“COST” key to alternate between “COST/D”,
“COST/M” and “COST/Y” displays. Now check that
all the values displayed are set to zero as follows: