La Crosse Technology 616-146 - Manual (Page 4)

4
ATOMIC SIGNAL SEARCH:
The LCD backlight, projection and USB charging port will momentarily turn off while the station searches
for the atomic signal. After the initial search, this station will only search for the atomic signal after
midnight.
Install Batteries in the TX141 Transmitter
NOTE: This projection alarm will come with one TX141 transmitter OR one TX14 transmitter.
Both transmitters work interchangeably.
1. Slide the battery cover down, then lift off the front of the TX141 transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Confirm the channel selector switch is on channel 1.
3. Insert two new AA batteries into the transmitter.
Observe the correct polarity (see marking inside battery compartment).
4. Keep transmitter 5-10 ft. from the forecast station during setup.
5. After 15 minutes, if the outdoor temperature shows on the forecast station,
move the outdoor transmitter outside to a shaded location within range of the
forecast station.
Install Batteries in the TX14 Transmitter
1. Slide the battery cover down, then lift off the back of the TX14TH transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Confirm the channel selector switch is on channel 1.
3. Insert two new AA batteries into the transmitter.
4. Observe the correct polarity (see marking inside battery compartment).
5. Keep transmitter 5-10 ft. from the forecast station during setup.
6. After 15 minutes, if the outdoor temperature shows on the forecast station, move the outdoor
transmitter outside to a shaded location within range of the forecast station.
Function Buttons
Button Press and Release Functions Hold 2 seconds
SET/°C/°F Move through program menu (setup)
Select temperature in °C/°F Enter program menu, set time,
date, etc. (setup)
ALARM Once: View Alarm
Twice: Activate or Deactivate Alarm Alarm set
+/TEMP 1 step forward (setup) Search for Sensor
Fast advance (setup)
-/TIME 1 step backward (setup) Fast backward ( setup)
WWVB Search
PROJECTION Rotate Projection 90 degrees Change what is projected:
Time/Outdoor Temp alternating
(default)
Once: Time only
Twice: Outdoor Temp only
Third time: Time/Outdoor Temp
alternating (default)
SNOOZE/LIGHT/HI/LOW/OFF (TOP)