La Crosse Technology TX25U - Manual (Page 5)

5
4. Through the 3 screw holes of the bracket, mark the mounting surface with a pencil.
5. Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the
bracket.
6. Insert the remote temperature sensor into the bracket.
Problem:
No outdoor temperature is displayed.
Solution:
1) Remove all batteries, reinsert into sensor first, then into the wireless weather station.
2) Place remote temperature sensor closer to wireless weather station.
3) Be sure all batteries are fresh.
4) Place remoter temperature sensor and wireless weather station in position so the straight-line
signal is not passing through more than 2 or 3 walls.
Problem:
Temperatures do not match if units are placed next to each other.
Solution:
Each remote temperature sensor is manufactured to be accurate to within 1 degree plus or
minus and under normal conditions, so two sensors could be as much as 2 degrees different.
However, the difference can be exaggerated further because the sensors are designed for
different working environments. The indoor sensor is less responsive to ambient air currents
because of the shielding effect of the display's case. In addition, the case can act as a heat
sink to absorb and store heat from external sources (i.e. handling of the case or radiant heat).
Also, the much greater range of the remote temperature sensor requires a different calibration
curve than the indoor range. Error is usually greater at the extreme ends of a range, making it
harder to compare different ranges with different curves. Under non-laboratory conditions, it is
difficult to compensate for the above factors and obtain an accurate comparison.
MAINTENANCE AND CARE INSTRUCTIONS
9 Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units.
9 Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they
may mark the displays and casings.
9 Do not submerge in water.
9 Immediately remove all low powered batteries to avoid leakage and damage.
9 Opening the casings invalidates t he warranty. Do not try to repair the unit. Contact La Crosse
Technology for repairs.
WARRANTY INFORMATION
La Crosse T echnology, Ltd provides a 1-year limited warranty on this product against manufac turing defects in materials and
workmanship.
Bottom of sensor
inserted into Mounting
Bracket
Back middle of
sensor inserted into
Mounting Bracket