Lacava 4500G - Manual (Page 2)

LACAVA LLC
®
Page 2 of 7
Warranty
LACAVA warrants its products to be free from any defects in materials or workmanship, during
normal residential or commercial use, including all hinges, drawer slides, cartridges, finishes, and
general workmanship of the item. LACAVA warranties do not cover normal wear and tear,
damages due to negligence, improper installation, alterations, improper repairs, improper use,
improper maintenance, or damages due to uses of the product other than its intended and
normal use. All warranties last for a period of one year from the date of purchase. If a defect is
found under normal use, while under warranty, LACAVA will repair or replace the product
(whichever cost is smaller to LACAVA) at its own expense (excluding shipping and installation
charges). Under no circumstances is LACAVA responsible for installation/service fees or any dollar
amount beyond the cost of the item. In addition, all LACAVA products are to be installed by
experienced professionals properly licensed and bonded; otherwise, any LACAVA warranty and
liability is to be considered waived. All warranties are non-transferable and proof of purchase is
required for any warranty claim.
In accordance with the laws of limitation and exclusion state by state, and therefore provided the
duly exceptions, LACAVA will not be held liable, in any event, for any special, indirect, incidental or
consequential damages or losses (including but not limited to damages for loss of business, loss of
profits, etc.) for breach of contract, tort (including negligence), product liability or otherwise, even
if it has been advised of the possibility of such damages. LACAVA’s liability on any claim (including
negligence) will not in any case exceed the contract price paid by the original purchaser for the
product claimed defective or unsuitable. It is the responsibility of the homeowner to ensure that all
installed fixtures comply with all local plumbing codes.
Cleaning & Care Instructions
VITREOUS CHINA:
Vitreous china can be cleaned with a range of cleaning agents designated for bathroom
maintenance: only strong acids and abrasive agents should be avoided in order to prevent
discoloration and scratches in the glazed surface. Wash with detergent and warm water and rinse.
Black marks in the glaze created by contact with metal elements can be removed with very fine
steel wool. The marks should be damped with water or glass cleaner and rubbed with steel wool
until it is removed (this may take longer than a couple of minutes).
Lime deposits may be removed by a solution of vinegar and water. Bathroom fixtures should be
disinfected weekly with a solution of chlorine bleach and water or a spray-on disinfectant or by using
disinfectant cleaning foam. Rust stains can be removed by using commercial rust remover or by
using a solution of 1 tablespoon oxalic acid crystals (poison), dissolved in ½ cup warm water. Apply
to stain, allowing to stand a few minutes, and then rinse well.
ACRYLIC & SOLID SURFACE:
Acrylic and solid surface is non-porous so liquids cannot penetrate it. Use water with dish soap or an
ammonia-based cleanser (such as glass cleanser).Wipe away water stains with a damp cloth and
sponge and dry with a towel. Occasionally wipe sinks and bowls with diluted household bleach (1/1
water/bleach solution) to disinfect. Surfaces exposed to acetone-based polish removers and paint
removers should be promptly flushed with water. To remove stains, use Soft Scrub (or) diluted bleach
and a sponge to rub in circular motion. If the area is dull in contrast with the surrounding surface, use
a white polishing compound with a sponge to get a higher gloss. To remover cuts and scratches,
sand with 400-grit (30 micron) or 600-grit (20 micron) sandpaper; buff with polishing pad at a low
speed (1,500 - 2,000 rpm) polisher equipped with a wool pad; finish with wax.
We would like to thank you for your purchase and are confident that you will be able to
enjoy our products for many years to come!