Legrand 291-H/BTC User Manual
Page 4
4
Step 2: Remove disposable plate from poke-thru
Step 3: Attach 1/2" trade size conduit fitting
stem. Place trim flange and hex housing
(not provided) to poke-thru power conduit.
conduits and mounting holes. Install
Connect to junction box (not provided).
four #6-32 mounting screws. Make sure
Connect 3/4" trade size flexible metal conduit
gasket is in place between the hex housing
and fitting to conduit adapter and insert into
and trim flange.
hex housing. Secure with #10-24 mounting
screw. Complete installation per NEC and
local codes
Step 4. Insert power barrier and secure with
Step 5. Installation complete.
#6-32 barrier mounting screw. Attach
cover with four #6-32 flathead screws.
Four #6-32 Mounting Screws
Tighten #10-24 Mounting
Screw After Conduit
Adapter (Provided) is
Slid into Housing
1/2" Trade Size Conduit
Fitting (Not Supplied)
(When used in environmental
air handling spaces.)
Once Poke-Thru is Pushed
into Cored-Hole, from Below,
Install a EMT Compression
Fitting (Not Supplied) and
Junction Box (Not Supplied)
to the Conduit System.
Complete Installation Per
NEC and Local Codes.
Conduit Adapter
3/4" Trade Size
Conduit Fitting
(Not Supplied)
3/4" Trade Size Flexible
Metal Conduit (Not Supplied)
Junction Box
(Not Supplied)
#6-32 Barrier
Mounting Screw
Four #6-32
Flathead Screws
Power Barrier
Communication
Grommet
Remove if RC9FFS is Applied
Gasket
NOTE: Conduit Adapter in Step 3 may be used for
connecting conduit containing communication
type cables. Remove applicable Communication
Grommet and replace with Cat. No. FFD-P.