DYSON DCO3 - Manual (Page 3)

Blockages and brushbar
Remove wand from hose and look
down the wand to check for daylight.
Locate blockage removal cassette catch
at base of hose location.
2
Pull back catch, remove cassette and
check for blockage. To replace, position
at 45
0 and click catch back into place.
Remove Cyclone assembly to check
Cyclone entry and duct.
2
4
Using a coin, undo the yellow fastener
to remove the quick release window.
Check for blockage at the bottom of the
duct and underneath the soleplate. 1
1 4
3
Cyclone entry
Blockage removal
cassette catch
duct
3
If ratchet warning noise continues, stop
vacuuming, turn off the machine and
unplug. To free the brushbar, lie the
machine on its front to reveal the soleplate.
1 2
3
4 Using a coin, undo the three yellow
fasteners. To replace brushbar, align and locate
in slots. Rotate until the end caps click
into place. Rotate brushbar to allow belt
to centralise, then replace soleplate.
1 2 3 4
If the brushbar is obstructed, a loud ratchet warning noise will be heard. Pull the cleaner away and it will automatically re-set itself.
For thread removal, unplug cleaner and carefully cut away threads from brushbar.
End cap of brushbar
Raised section
Remove soleplate and clear the
brushbar obstruction.
Unplug your cleaner before carrying out any maintenance.