Legrand DS4000 End Fittings - Manual (Page 2)

TAMPER RESISTANCE KIT
Step 1. Locate dimple on fitting and use as guide
to drill hole for tamper resistant screw.
To make the DS4010A Fitting fully tamper resistant, use part no. DSTRK. Use a 3/16" [5mm] drill bit and drill
a hole at the dimple point shown below. Install the tamper resistant screw with the bit supplied.
Step 2. Install supplied tamper resistant screw through
drilled hole into tab on back.
Step 3. Installation complete.
COVER REMOVAL
To remove Cover, use 650RT Cover Removal Tool, or carefully use a small flat blade screwdriver and pry up as shown.