Legrand DRD6 v2 - Manual (Page 8)

set house iD
All Miro wireless devices installed in the same home must acquire the same
unique House ID before use. This process is known as house binding. Each Miro
wireless device is bound to all other Miro wireless devices in the house.
new installation
1. With all devices installed and energized, make sure that every Miro wireless
device LED is yellow. If any LED is off, be sure the circuit breaker is on and the
device is correctly installed.
2. Press on any device paddle until
the LED flashes yellow (about 2
seconds). This indicates that it has
acquired a unique House ID.
3. Make sure that all other Miro
wireless device LEDs are flashing
green, indicating that they have
acquired the same House ID.
4. Return to the device used in step 2, which is still flashing yellow. Press until
the LED changes to solid green (about 2 seconds). All device LEDs in the House
change to solid green, indicating house binding is complete.
adding an DrD6 to an existing installation
If you’re adding or replacing a DRD6 in a Miro wireless installation that is already
operating, the new DRD6 must acquire the same House ID as the other Miro
wireless devices in the house. After the new DRD6 is powered up, the LED should
be solid yellow. This indicates that it has not yet acquired a House ID. To acquire
the House ID for the existing system:
1. Press on any previously bound device until the LED flashes yellow (about 2
seconds).
2. Verify that the newly added DRD6 LED is flashing green, indicating that it has
acquired the House ID.
3. Return to the same previously bound device used in step 1 and press until
the LED changes to solid green (about 2 seconds). All device LEDs should now
be solid green.
When you see
in the instructions,
firmly press and
hold both the top
and bottom of
the paddle until
the LED changes
(about 2 seconds).
When you see in
the instructions, touch
the top of the paddle
as directed. When you see in
the instructions, touch
the bottom of the
paddle as directed.