Leprecon VX Series Dimmer User Manual
Page 7
7
to the board control channel 1. Setting the switches to 13 will cause the first dimmer channel to
follow board control channel 13. This would be the case when a second 12 channel VX / MX is
used as part of a larger system.
The control electronics is programmed to ignore changes to the address thumbwheels until the
switches have stopped changing. For this reason, it will require a moment for the dimmer to
accept a new address after the switches have been changed
The LED labeled "Match" will light when a DMX channel equal to the switch setting is received.
For example, if the Start Address switches on the Control drawer are set to 500, and the console
is only outputting 256 DMX channels, the Match LED will not light, and no dimmer channels can
be turned on.